 Posted: Wed Aug 27, 2008 6:42 am |
 |
|
| rrodolphe |
| Member |
|
| |
| Joined: 30 Aug 2007 |
| Posts: 35 |
| Location: france |
|
|
 |
|
|
| Hello I use easera systune, it's a very cool tools but I have a sugestion.
When you make a calibration with a configuration (microphone and audio device) it's impossible to record the calibration.
Can you see if is possible to save the level calibration to save time measurement?
thany you |
|
|
|
|
| Posted: Wed Aug 27, 2008 7:07 am |
|
|
| Bruce |
| Member |
|
| |
| Joined: 19 Apr 2005 |
| Posts: 460 |
| Location: Minneapolis, MN, USA |
|
|
|
|
|
| Under the File Menu you will find Save Setup File and Open Setup File. These will save and recall both the audio device used, as well as all the calibration values you have entered for each channel. Also, the calibration is remembered and recalled when you close EASERA SysTune, and then re-start it later.
Note that if you select another audio device or Sample Rate, the calibration values are reset to Full Scale. So you should save a Setup file for each type of configuration that you use. |
|
|
_________________
Best Regards,
Bruce C. Olson |
|
|
|
| AFMG Network Forum Index -> AFMG SysTune |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
