 Posted: Fri Jul 22, 2016 12:18 am |
 |
|
| nhenrys |
| Member |
|
| |
| Joined: 22 Jul 2016 |
| Posts: 3 |
|
|
|
 |
|
|
| Hi all,
I can't figure out how to correctly show the Total SPL Broadband A-Weighted to show in Standard Mapping results.
The results for individual octave bands appear higher than the broadband level, which makes no sense!
For example I am getting Max = 74.82 for 1000 Hz One Octave A-Weighted but Max = 70.18 dB for Broadband.
Selecting the range 100Hz - 10000Hz also returns max = 70.18.
Any help would be much appreciated. |
|
|
|
|
| Posted: Fri Jul 22, 2016 1:12 am |
|
|
| Jim Mobley |
| Member |
|
| |
| Joined: 27 Jul 2005 |
| Posts: 134 |
| Location: Foothill Ranch, California, USA |
|
|
|
|
|
| Hi nhenrys,
In Edit Project, from the Edit menu select Room Data, then select the Settings Tab, then select Pink noise input signal using the radio button. OK out and Check Data (F5). You may have to adjust the output levels of your loudspeakers, see the FAQ post here:
http://afmg-network.com/viewtopic.php?t=1155 |
|
|
_________________
Best regards,
Jim Mobley
Sr. Application Engineer
Renkus-Heinz, Inc.
19201 Cook St.
Foothill Ranch, CA 92610 USA
TEL: +1-949-588-9997
FAX: +1-949-588-9514
www.renkus-heinz.com
mailto:jim@renkus-heinz.com |
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
