 Posted: Tue Sep 06, 2016 8:01 pm |
 |
|
| jkosco |
| Member |
|
| |
| Joined: 06 May 2014 |
| Posts: 4 |
|
|
|
 |
|
|
| I am working on creating some trace files to analyze reflector spacing and angles. I have traced the 1st order reflections due to a source on the stage from only the reflectors. However, once the rays reach the floor, they continue on outside of the model.
The model is closed so I don't believe the rays should be exiting.
Is there a way to have the rays stop at the floor? It looks like there may be based on pictures in the manual.
Thank you. |
|
|
|
|
| Posted: Wed Sep 07, 2016 1:39 pm |
|
|
|
| Make sure all faces have the right orientation: Yellow side inside the room and white side outside the room.
Frank Siegmann
AFMG |
|
|
|
|
| Posted: Fri Sep 09, 2016 4:44 pm |
|
|
| jkosco |
| Member |
|
| |
| Joined: 06 May 2014 |
| Posts: 4 |
|
|
|
|
|
|
| All the faces have the right orientation. There are no holes and it is a closed room. Are there any other ideas? |
|
|
|
|
| Posted: Mon Sep 12, 2016 1:58 pm |
|
|
|
| If possible please send us your EASE project to check it here?
Before sending please pack the project using "File > Pack Project" from EASE main module.
Frank Siegmann
AFMG |
|
|
|
|
| Posted: Mon Sep 12, 2016 1:59 pm |
|
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
