| Adding Skylight to flat roof |
 Posted: Fri Oct 07, 2022 9:19 pm |
 |
|
| hp999 |
| Member |
|
| |
| Joined: 17 Dec 2010 |
| Posts: 2 |
|
|
|
 |
|
|
| I am trying to add skylights to a flat roof and extrude them upward to create a cavity. My problem is with the flat roof. It is 4 vertex points (4 corners). How do I coat the skylights to the roof, they is no "hole into the roof. Do I have to generate multiple faces on the roof so I can create a hole for the skylights?
Any suggestions? |
|
|
|
|
| Posted: Mon Oct 10, 2022 8:58 am |
|
|
|
| Straight away I would say, yes, you need to build several faces to implement your design. However, to be sure, please send me your project packed by EASE (EASE Main Window -> File -> Pack Project) to support@afmg.eu. In addition, a small drawing or similar (rudimentary) of your project or a description of which area, size or similar would be very helpful to be able to have a closer look at your project and give you an individual answer.
Regards,
Silke |
|
|
|
|
| Posted: Wed Oct 12, 2022 3:35 am |
|
|
| hp999 |
| Member |
|
| |
| Joined: 17 Dec 2010 |
| Posts: 2 |
|
|
|
|
|
|
| Thanks for replying. I did create multiple ceiling areas to carve out the skylights. Was easier than I thought. Thanks for your offer.
HP999 |
|
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
