| special geometry alteration, face groupings, and project alt |
 Posted: Tue Jul 21, 2009 2:38 pm |
 |
|
| kudzudav |
| Member |
|
| |
| Joined: 21 Jul 2009 |
| Posts: 7 |
| Location: oxford, ms |
|
|
 |
|
|
| I had three questions:
1) on an imported curved wall I have 250 surfaces, and I wish to make them layered on the top 1/2 with a new material. Any shortcuts other than to extrude the line segment at the top 1/2 way down?
2) each of these surfaces will need to be made into a new material again: while I can use the optimizer if they are a unique material, is there a way to mark faces (i.e. in the spreadsheet) spread out in a room to change them all simultaneously?
3) what is the recommended method for saving a project at a given point in order to create several alternate approaches from that point (geometry, finishes) that may be in different directions. I can save the data but not "save as". do you make a copy and re-name it?
thanks
dave |
|
|
|
|
| Posted: Tue Jul 21, 2009 3:53 pm |
|
|
| kudzudav |
| Member |
|
| |
| Joined: 21 Jul 2009 |
| Posts: 7 |
| Location: oxford, ms |
|
|
|
|
|
| Bruce gave me the down-lo:
1) extruding the segment will have to do.
2) any set of faces can be grouped as an object and then properties assigned in a blanket fashion. the object does not need to be "connected" in space
3) "save as" (while the edit project is open) from the main screen. From edit mode you can only save the project under the current name.
Thanks Bruce! |
|
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
