| bthornock |
| Member |
|
| |
| Joined: 15 Jul 2009 |
| Posts: 5 |
|
|
|
 |
|
|
| I just installed EASERA on a different computer (3 GHz, 3.5GB RAM, MOTU 896mk3) and created some bandlimited excitation signals (weighted sweep) like I have done previously. However, upon playing the signal back in live mode, the frequency output only goes up to approximately 1.5 kHz when my cutoff is supposed to be 22kHz. I am sampling at 192 kHz and want to create signals 2.7s and 5.5s in length. I did find that I could successfully make 1.4s signals with the appropriate frequency range that plays the entire range, but I plan to use these signals in rooms with longer reverberation times and hope to get this working correctly. Any suggestions? |
|
