 Posted: Thu Aug 27, 2009 2:46 pm |
 |
|
| pasound |
| Member |
|
| |
| Joined: 04 Jun 2008 |
| Posts: 10 |
|
|
|
 |
|
|
| Can anyone tell me the best way to view a flutter echo in an EASE room model? I have a customer who is very intrested in seeing the flutter echos and where they are comming from. any help
Thanks,
Dewey |
|
|
|
|
| Posted: Thu Aug 27, 2009 5:14 pm |
|
|
| Jim Mobley |
| Member |
|
| |
| Joined: 27 Jul 2005 |
| Posts: 134 |
| Location: Foothill Ranch, California, USA |
|
|
|
|
|
| Hi Dewey,
You can do this in Ray Tracing, but describing all of the necessary steps in detail is beyond what can be posted here.
In short, do a Ray Tracing calculation, probably 4-5k rays/lsp, 10th order/no time limit.
Then use the controls in the Ray Tracing Item Menu, Use only Selected Faces and Draw Only Selected Rays, activate the parallel faces causing the flutter echo and use Draw All Rays or the Movie to see the flutter echo. If you don't get any Rays showing up between parallel faces, try using more Rays or fewer orders during the calculation. |
|
|
_________________
Best regards,
Jim Mobley
Sr. Application Engineer
Renkus-Heinz, Inc.
19201 Cook St.
Foothill Ranch, CA 92610 USA
TEL: +1-949-588-9997
FAX: +1-949-588-9514
www.renkus-heinz.com
mailto:jim@renkus-heinz.com |
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
