| Negativ Volume of the room, negativ Reverb Time |
 Posted: Sun Feb 14, 2010 11:52 am |
 |
|
| haens |
| Member |
|
| |
| Joined: 14 Feb 2010 |
| Posts: 1 |
|
|
|
 |
|
|
| after importing a sketchup model, the room data-window shows a negative volume and negativ RT. Tried several times to import the model in different ways, even as a dxf, but it's still negativ. Where is my mistake??
Thanks for every answer... |
|
|
|
|
| Posted: Sun Feb 14, 2010 7:59 pm |
|
|
| Stefan |
| Member |
|
| |
| Joined: 19 Apr 2005 |
| Posts: 167 |
| Location: Berlin, Germany |
|
|
|
|
|
| Make sure that the faces of the room are looking into the room not out. With standard colors, a face is yellow if you are looking at its inside-facing surface, it is white for the outside. Use RMB/Invert or the properties sheet to invert it. You can use the Check Holes function with a correct face selected to turn all other faces into the same direction.
Stefan |
|
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
