| Editing spectrum in live mode |
 Posted: Tue Mar 03, 2015 12:38 pm |
 |
|
| Bartek Zdeb |
| Member |
|
| |
| Joined: 16 May 2011 |
| Posts: 11 |
| Location: Poland |
|
|
 |
|
|
| Hi,
Is it possible to edit the file .els with saved spectrum?
If so, how?
I would like to edit or to do spectrum with the noise eg. NC-30 or any.
Thus prepared, I will use the file as a noise file to correct the STI.
Does anyone know the solution?
Thanks in advance.
Bartek |
|
|
_________________
best regards,
bartek |
|
|
|
| Posted: Tue Mar 03, 2015 5:04 pm |
|
|
| Bruce |
| Member |
|
| |
| Joined: 19 Apr 2005 |
| Posts: 460 |
| Location: Minneapolis, MN, USA |
|
|
|
|
|
| Hello Bartek,
It is not possible to edit the .ELS file. However, there is an easier way. On the STI Properties page you can directly enter the Octave Band values in the text boxes for the Spectrum and/or the noise. |
|
|
_________________
Best Regards,
Bruce C. Olson |
|
|
|
| Posted: Wed Mar 04, 2015 11:30 am |
|
|
| Bartek Zdeb |
| Member |
|
| |
| Joined: 16 May 2011 |
| Posts: 11 |
| Location: Poland |
|
|
|
|
|
| Hi Bruce,
Thank you for your reply. I know I can do it as written. The method is good for several samples, but with more example eg. 100 is very time-consuming. Mostly during STI measurements background noise is low. In fact, it is much higher. For convenience, in many cases, to measure background noise I use the handy octave (1/3 octave) analyzer or get a background sound from third parties. In such cases, I would like to quickly correct the measured STI for 100 points.
How to do this quickly?
Thanks in advance. |
|
|
_________________
best regards,
bartek |
|
|
|
| Posted: Wed Mar 04, 2015 5:24 pm |
|
|
| Bruce |
| Member |
|
| |
| Joined: 19 Apr 2005 |
| Posts: 460 |
| Location: Minneapolis, MN, USA |
|
|
|
|
|
| Hi Bartek,
There are two places to set this. If you do it in Options [F9] before loading the files, it is remembered for every file. If you use Properties [F4], then it only changes it for the current file. |
|
|
_________________
Best Regards,
Bruce C. Olson |
|
|
|
| Posted: Tue Mar 10, 2015 8:48 am |
|
|
| Bartek Zdeb |
| Member |
|
| |
| Joined: 16 May 2011 |
| Posts: 11 |
| Location: Poland |
|
|
|
|
|
| Hi Bruce,
Thank you so much for your help. |
|
|
_________________
best regards,
bartek |
|
|
|
| AFMG Network Forum Index -> AFMG EASERA |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
