 Posted: Tue Nov 15, 2016 5:46 pm |
 |
|
| Magarva |
| Member |
|
| |
| Joined: 15 Nov 2016 |
| Posts: 1 |
|
|
|
 |
|
|
| Hello, it is my first time writing here. I hope you could help me 
I'm working with EASE 4.3, and I need to add a reflector in my room. I have tried putting a face with the scattering in 1, but I get the same solution when I put the face completely absorbent.
I am comparing the SPL, and there is no difference between these two cases.
Thanks |
|
|
|
|
| Posted: Wed Nov 16, 2016 10:25 pm |
|
|
| thomas |
| Member |
|
| |
| Joined: 16 Mar 2011 |
| Posts: 73 |
|
|
|
|
|
|
| Welcome!
Please give some basic informations about Your project and what You've done.
- What SPL? Total or direct?
- What room (size, shape)? Where is the reflector (size, shape, position)? Post a picture, if possible.
- What simulation method did You use?
kind regards
Thomas |
|
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
