 Posted: Thu Jan 19, 2006 5:27 pm |
 |
|
| David Peterson |
| Member |
|
| |
| Joined: 19 Jan 2006 |
| Posts: 1 |
| Location: Minneapolis Minnesota |
|
|
 |
|
|
| After doing a Ray Tracing calcuation EASE allows us to view the results with the Probe. My question is, can the probe be set to display specific parameters as a default. Lets say the reflectogram would always show me 0-120 ms and 0-90 dB.
The reason for my question is that I would like to compare one result to another and want to understand how the probe establishes it coordinates.
Are here parameters that I can set before the calculations to get the consistancy I'm looking for? |
|
|
|
|
| Posted: Fri Jan 20, 2006 12:37 pm |
|
|
| Bruce |
| Member |
|
| |
| Joined: 19 Apr 2005 |
| Posts: 460 |
| Location: Minneapolis, MN, USA |
|
|
|
|
|
| With the Probe window press F9 to open the Options dialog. On the Legend tab you can set the desired graph parameters separately for the Ordinate and Abscissa of each graph type. To do what you want to do, you set the parameters for the graph, then check the Lock Axis checkbox. Apply will show you the changes and/or OK will close the dialog with the changes shown. These settings are retained between EASE sessions. |
|
|
_________________
Best Regards,
Bruce C. Olson |
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
