 Posted: Thu Aug 31, 2006 3:39 am |
 |
|
| Varun |
| Member |
|
| |
| Joined: 08 Aug 2006 |
| Posts: 14 |
|
|
|
 |
|
|
| Does EASE have a feature that can enable us to make curved audience areas?
Also, is the audience area only limited to 4 vertices or can this be extended?
Thanks. |
|
|
|
|
| Posted: Thu Aug 31, 2006 3:40 pm |
|
|
| Jim Mobley |
| Member |
|
| |
| Joined: 27 Jul 2005 |
| Posts: 134 |
| Location: Foothill Ranch, California, USA |
|
|
|
|
|
| Hi Varun,
Have a look at the Amphitheater prototype to see an example of how to handle curved audience areas.
Audience areas must have four--and only four--sides. And cheating by adding a vertex to the side of a triangle can lead to calculation errors. In Eyes, you can map to faces and the four side limitation does not apply. However, you lose the option of the isolines. |
|
|
_________________
Best regards,
Jim Mobley
Sr. Application Engineer
Renkus-Heinz, Inc.
19201 Cook St.
Foothill Ranch, CA 92610 USA
TEL: +1-949-588-9997
FAX: +1-949-588-9514
www.renkus-heinz.com
mailto:jim@renkus-heinz.com |
|
|
|
| Posted: Sat Oct 14, 2006 10:28 pm |
|
|
| Ron Sauro |
| Member |
|
| |
| Joined: 29 Oct 2005 |
| Posts: 27 |
| Location: Elma, Wa |
|
|
|
|
|
| Hi Varun,
When you use the audience areas with four vertices there is a limit on how short the short side of a trapazoid can be ..... it seems to start to cause a calculation error when the short side is less than 1/2 of the opposite side in length... so as an example if 2 sides that are angles are equal in length at say 10 meters and the top is 5 meters then the lower edge cannot be less than 2.5 meters
Ron Sauro
NWAA Labs |
|
|
|
|
| AFMG Network Forum Index -> EASE 4 |
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
All times are GMT
Page 1 of 1
|
|
|
|
|
